user:

Satin Chrome Adjustable Slim Line Glass Mount Fitting

S13
Glass Edge Clamp
  • Fits 3/4" bar
  • Solid Brass Construction
  • Grub Screw Locks Bar In Place
  • Nylon Tip Screws Clamp Glass
  • This Adjustable Slim Line Fitting is designed to be installed when the support bar has to be the same height as the fixed panel. This Wall Mount Fitting can be moved to any desired location on the panel where a support is required. It is designed to be used with our Support Bars.

Weight & Width*
Glass**
Glass***
2 Hinges (Max Door Width)

  in.

  in.

2 Hinges ( Max Door Weight)

  lbs.

  lbs.

3 Hinges (Max Door Width )

  in.

  in.

3 Hinges (Max Door Weight )

  lbs.

  lbs.

* NOTE: Do not exceed either maximum weight or width when choosing proper quantity of hinges.

Glass Cutout:

The cutout for the hinge allows some adjustment in door position after installation. The positioning of the cutout is subjective, but tempering facilities have minimum distances from the end of the glass to the notch. It is important that the hinge is centered in the cutout for the initial installation to have maxium adjustiability.

 

S13 Cutout

Maintenance Guidelines:

• Our hinges are greased at the factory for quiet and trouble-free operation. If there is any squeaking that occurs after installation, put a drop of "3 in 1 Oil" (also known as "household oil") on the white nylon washer that the hinge body pivots on. This washer is the component that acts as a buffer, so the body of the hinge doesn't pivot directly on the brass center block. This solution doesn't require the disassembly of the hinge.
Note: Do not use spray lubricant on these hinges. If the hinge has been disassembled, upon re-assembly, use white lithium grease to lubricate the interior mechanism.

Never use an abrasive cleaner on the hardware. Many of the components are coated with a clear lacquer that will be irreparably damaged if subjected to harsh, abrasive chemicals. Advise your customer that drying the hardware with a clean, soft towel on a daily basis is the best way to maintain the hardware. If mineral deposits build-up, mix a couple of drops of a mild liquid soap (such as Ivory or a similar product) into a cup of warm water. Using a soft, non-abrasive cloth, clean the hardware. Rinse thoroughly with clean, warm water and dry.